A Decorative Ring made with a 4-straw Compass Plait
An ideal Christmas project. It can be adapted in many ways either as a Christmas tree decoration or glued onto a card.
You will need:
Tools
- Scissors
- Seam Ripper (optional)
- Flat bladed knife, smoother or Hindenburg.
Materials
- 4 straws for a length of 4-Straw Compass Plait
- Glue stick (not runny glue)
- Sticky Tape
- Red cotton (approx. 15cms for each heart)
- Hollow dyed red straw
- Paper (red and white)
- Prepared straw ring, and/or blank greetings card of choice
To make a 4-straw Compass Plait
This is an easy and very effective 4-straw plait.
Step 1
Tie 4 straws tightly together under the heads with a clove hitch. Spread out into NESW.
Step 2
Bring N down to lie by S. Take S up to where N was.
Step 3
In a similar move, bring E across to lie by W. Take W across to where E was.
It is important to keep the straws parallel as they cross over. Looking down on your plait it should look like this:
When you have completed the required length of plait, bring all four straws up together and tie securely with a clove hitch.
To make the decorative ring
Plait a sufficient length of 4-straw Compass Plait (see above) Cut off the wheat ears, and tie one end of the plait to the other, in a loop. Place your loop in a heat proof jug and cover with hot water; allow it to soak for a few minutes. This will render the plait pliable again. Remove the loop and place round a circular former (plastic pill bottle, pie funnel, etc.) that is large enough to stretch the plait very slightly. Allow to dry overnight, then remove from former. This should result in a nicely circular ring.
Making the marquetry heart
Preparation:Draw out on your red paper one block of eight 1.5cm squares arranged in one line.
Draw out two blocks of four 1.5cm squares arranged in a cube.
Tip: Rule out a complete sheet of A4 white paper into 1.5cm squares, and keep this as your master copy.
Photocopy this sheet on to red paper. You can then easily cut out your single line of 8 blocks and your two squares of 4 blocks.
Trace off and cut out the heart shape on to card for use as a template.
Preparation of straw ribbons – see steps 2, 3, 4 in the Greetings Card project.
Each heart will require one or two strips (depending on the diameter of your straw) of not less than 12cms in length.
The marquetry heart
Step 1
Place glue on the pith side of your straw ribbon and stick it on the blank side of the long strip of red paper. If you are using thick straw, one straw ribbon should be sufficient to cover the paper, but if it is not, then you will need a second strip. Make sure the second strip is butted up to the first one and no paper shows through. If possible, allow to dry thoroughly under a weight.
Step 2
Turn the strip over, and carefully cut across the lines. This will give you eight identical straw squares.Step 3
Take one of the square pieces of red paper and fold in half on the central line, then open it out again (you will see why later). Now carefully stick four of your small straw squares in place using the lines as a guide BUT stick one square with the grain of the straw horizontal, and the one next to it with the grain vertical. Most important of all is to ensure that the squares meet in the centre. The outside edges are not so critical as they will be trimmed off. Now repeat this process with the other piece of paper and the remaining four straw squares. Again, allow to dry thoroughly under a weight, if possible.
Step 4
Now take your card heart template, and trace off the shape onto the back side of each of your two squares, lining up the heart on the central crease that you made earlier. Cut out each heart.
Step 5
On the paper side of one of the hearts, secure your piece of red cotton thread with a very small piece of sticky tape, then stick the two hearts together, back to back. Trim if necessary.
Step 6
Secure the heart to the straw ring, allowing it to hang freely.
Step 7
With the remaining thread make another loop as a hanger.
Variations
- Add a sprig of holly to a plaited ring for a simple Christmas tree decoration.
- Glue a heart on to a contrasting colour card to make a gift tag , or use it on its own as a Christmas tree decoration.
- Using the blocks technique, you can prepare a much larger sheet of marquetry squares and paste this onto a card blank. An aperture card such as this heart shape is ideal.
Supplies
Materials
Elaine Lindsay
Something Corny, Rowan Cottage, Inveramsay, Inverurie, Aberdeenshire, AB51 5DQ. Tel. 01467 681330
Something Corny supply Dyed Straws, Bleached Straws and Natural Straws. These items are available by post from Elaine Lindsay.
Elaine is a member of the Guild and is experienced in many aspects of straw craft.
Your Local Florist
Your local florist may have suitable straw. Remember that the straw has to be hollow and, if possible, thin walled.
Equipment
Elaine Lindsay
Something Corny, Rowan Cottage, Inveramsay, Inverurie, Aberdeenshire, AB51 5DQ. Tel. 01467 681330
Something Corny supply Plastic Straw Splitters, Star Frames and Instruction Books.
Gordon Thwaites
Garth Nest, Kentmere Road, Staveley, Kendal, Cumbria LA8 9JF
Gordon makes tools for straw work and so a Hindenburg can be bought from him.
Gordon is a clock maker by profession; his tools are made to very high standards. All his tools are works of art in themselves.
Further Reading
Creative Straw Marquetry
Freda Rudman
Paperback. Pub. Wessex Press, Wantage, Oxon. (1984) ISBN 0 948644 00 1
Straw Mosaics
Lina Croucher
Paperback. Pub. Reeves Dryad Press (1975) SBN 85219-091-3
